Vinyl Etched Decals
(static cling non-adhesive vinyl etchings)
 The look of real etched glass for much less!

Static Cling Decal Instructions

IMPORTANT: Read all Instructions Carefully Before Applying
 Clean hands thoroughly to prevent any dirt/oils from adhering to the surface of the decal. Also clean the area where decal will be applied thoroughly with window cleaner and wipe dry with a lint-free cloth.
 ***Note*** Do Not allow the backing paper that is against the decal to get wet!!!
If backing paper gets wet, you will not be able to remove the decoration from it and it will be ruined. Spray cleaned glass "very" liberally (the more liquid used - the easier the application) with water or glass cleaner before applying decoration. A substantial amount of moisture is required between the decal and surface to give an even appearance once fully dried. Never install on a dry surface. With dry hands, peel the decal from the backing paper. Lightly spray the back side (shiny side) of decal with water or glass cleaner. This will prevent it from clinging to itself and aid in its application. REMEMBER it is necessary to place the side of the decal that is against the backing paper to the glass. It will not adhere on etched side! If patterns are to face one another and, left & right designs are not available, apply one to the interior and one to the exterior of the surface. Place the shiny side of the decoration against the wet surface and then position it by sliding and moving into the desired location. At this point you may also want to spray the outside of the decal that you will squeegee. This will allow the squeegee to "glide" over the decal easier. Using a rubber-tipped squeegee, plastic driver's license or credit card (making sure there are no rough edges), work from the center outward and squeegee out "all" the excess air and moisture. Then, wipe dry with a lint-free cloth. If any tiny bubbles appear between the decal and the surface, repeat Step 4, making sure to thoroughly wet the "surface" again and squeegee "all" of the moisture out. Any excess moisture should evaporate within a 24 hour period.
PLASTIC WINDOWS: Interior application is recommended. Please check with the window manufacturer before applying window cleaner to any plastic surface. If window cleaner cannot be used, a very light soapy water solution is recommended for application and installation.
TINTED WINDOWS: Your decoration may give a more desirable appearance on the exterior surface, especially if the tint is dark. This has no adverse effect on your decoration.

GENERAL INFORMATION If, at any time bubbles occur (bubbles appear as little white dots), simply peel back the area affected and re-apply. Bubbles that are visible only from the glass side are due to insufficient moisture during application. Spray a generous amount of window cleaner to wet the glass and material before you squeegee. If you come across a stubborn edge that won't continue to cling to the glass, just spray more liquid under the area of the decal and use a blow dryer on a medium or warm setting and squeegee again. Print Instructions for future use. Vinyl Etched Decals are easily applied. Removable & Reusable. Just peel, spray, apply and squeegee.